 |
| picture blender |
Slow motor rotation
Halting the motor rotation
How to fix:
Check the electrical connecting cable is plugged in or dropped out? if there are no problems continue to point 2.
Separate glass blender of body weight blender and then turn it over to expose the bottom. Remove the bottom cover by opening the screws.
After the bottom cover apart then it will look like koponen: motor, capacitor, wiring. Check that each cable is installed properly or there is loose?
For motor rotation is the possibility of halting or brostel carbon brush is thin and that the case is ngefong, to fix it replace it with a new component quality and number one because if you use a carbon brush or brostel mediocre then age will not be long. Keep in mind that the size of the different components of the market then take sample pieces along with the rest of carbon brush holder when you are going to buy a replacement, if there is no size that fits then you can modify it in order to go on the stand.
Check the coil or spool on the motor is in a state of reasonable or black like burning? if colored
black and smell like burning the possibility of burning coil,
to make sure it can be measured with AVO meter how: Set the selector switch position on RX1 kilo ohms then paste each pen measuring AVO to plug both ends of the fingers, when the needle AVO silent then the motor windings AVO damaged but if the needle moves to the right and then silence the possibility of the motor is still in good condition.
When the coil or spool on the motor of the objec good
but the motor spins slow or no possibility of the capacitor is defective and must be replaced.
For slow rotation of the motor is usually due to a capacitor that is damaged, then replace it with a new capacitor.
"How to fix a motor coil or spool is damaged in a way entwined repeated, to workmanship give it to wrap services are usually united with service fees dynamo."
No comments:
Post a Comment