Friday, August 29, 2014

Service Blender

Some time ago there was a patient who complained blende crashed damaged and can not function normally.

The Blender brand MX-BG4N National Niko, judging from the damage looks like it is a way to fix the blender a bit easier than other electronic devices.

The main components of the blender consists of an electric motor with the coil, as well as some of the motor speed control switch. Of damage is seen that the total dead blender, then there is a possibility of experiencing problems at the source voltage cable, switch, or its electric motor.


Once I was unloading and carefully, it turns out both the cable and the switch still works fine. Physically speaking, the condition of the bike was not there is a fire, the coil is still in one piece.

Almost desperate as well because not found a bright spot, but finally I compare the blender working concept is almost similar to the fan. If the fan if you do not want to spin, could be damaged is the capacitor until the coil is broken.

My immediate loading and rotor electric motor, and it turns out after opening section, the blender electric motor is having problems. On the connection between the cable wires to the email with the switch having a sort of rusty so can not be connected properly. Soon I cleaned and re-solder, all the gentlemen I suspected re-solder. And apparently normal blender can be lit again, so that the finished repair dead blender that turned out rather time-consuming.

No comments:

Post a Comment